|
|
| IS7-G |
|
|
Intel 865PE Chipset Pentium 4 Mainboard
Dual SATA RAID, DUAL DDR 400, AGP 8X, USB 2.0
SoftMenu™ Technology
|
|
 BIOS:
|
|
is7g15.exe
|
Bios Issue Date: |
2003/07/14 |
BIOS ID:15
- Fixed the problem that no effect during POST if change "Delay IDE
Initial" in BIOS setup.
- Revised the wording of IEEE1394 controller in PCI device listing.
- Fixed the problem that DOS4GW.EXE causes system hang-up in DOS environment.
- Added function that automatically detects CPU operation speed after discharging
CMOS data.
- Added SATA RAID 1 function for Intel ICH5R south bridge.The IAA RAID driver should be updated to v3.5 or later to support RAID 1 in Windows
XP.
http://downloadfinder.intel.com/scripts-df/download.asp?url=/6363/eng/iaar35_enu.exe&ProductID=961
- BIOS Compile date: 7/14/2003.
|
|
|
|
is7g14.exe
|
Bios Issue Date: |
2003/07/02 |
BIOS ID:14
- Fixes wrong system operation caused by incomplete discharging CMOS
data by CCMOS jumper.
- Shows the correct IRQ of IDE Controller in PCI Devices Listing.
- Fixes CPU Thermal Throttling behavior while under minus temperature,
and supports minus temperature reading in BIOS Setup.
- Fixes the problem that system could not automatically get into S4
mode, after enabled Power Scheme of "Power Option" under Windows
XP
- Updates CPU Microcode (CPUID=0F13h, Patch ID=05h ; CPUID=0F12h, Patch
ID=02eh)?
- Fix the problem that PCU Slot Device in "-Bootabled Add-in Device"
function can not boot up in top priority.
- BIOS Compile Date: 7/02/2003
|
|
|
|
is7g13.exe
|
Bios Issue Date: |
2003/06/10 |
| BIOS ID:13
New Fixes/Features
- Added support for IS7-G, IS7, and IS7-E.
- Updated CPU micro code (CPU: 0F29H, ID=11H).
- Added CPU multiplier 8X for engineering sample CPU and maximum CPU frequency
412 MHz.
- Revised setup menu for OnChip Serial ATA.
- Fixed on-chip SATA boot issue while another bootable hard drives exist and
attached to IDE-1 or IDE-2.
- Updated memory reference code and ICH5 BIOS spec to v1.2.
- Fixed PS/2 mouse malfunctioning problem while the USB cable of Media XP
attached to mainboard.
- Fixed DOS 6.22 booting failure from FAT16 partition.
- Fixed BIOS hang-up problem which is caused by specific CPU cooling fan reporting
error RPM to BIOS when CPU FanEQ 60% enabled.
- Revised the following default settings in BIOS setup page. - Bootable Add-in
Device: PCI Slot Device - CPU FanEQ Active Temperature: 70 C - CPU Warning
Temperature: 85 C
- Added 80, 85, and 90 degrees C into "Shutdown Temperature".
- Enabled "IDE Block Mode" and hided the option.
- Revised ICH5R RAID BIOS display issue.
- Revised power-on delay time from 4~5 seconds to 1~2 seconds after AC power
lost and resumed.
- Added description for "Bootable Add-in Device".
- Fixed the problem that NB fan still reports full speed in PC Health page
when "CPU FanEQ Speed Control" is enabled.
- Added new option "IDE Bus Master".
- Added description for "Shutdown when CPUFAN Fail".
- Revised the wording of IDE channels inside the BIOS Setup. IDE Channel 0,
1, 2, and 3 are changed to 1, 2, 3, and 4.
- Added new option "SATA RAID ROM" to setup both "OnBoard SATA"
and "OnChip SATA".
- Added new option "HDD Change Message" in Advanced BIOS Features
and the default setting is "Disabled". If this option is changed
to "Enabled",the system will show warning message and prompt for
a confirmation whenone or more than one HDD had been added into or removed
from the system.
- Fixed "CPU THRM-Throttling" function.
- Added new options "Refresh Cycle Time", "Read Delay Adjust
(tRD Adj)", and "Command Per Clock (CPC)".
- Changed the default setting of "Drive A" from "None"
to "1.44M" after Load Fail-safe Defaults.
- Changed the default setting of "OnCip Serial ATA" to "Auto".
- Added "Game Accelerator" technology.
- Revised the error reading of fan speed for specific CPU cooling fan when
FanEQ 60% enabled.
- Fixed the slow detection problem when HDD simulation card installed.
- Fixed the problem that SMARTDRV.EXE malfunction in DOS 6.22 environment.
- Fixed the problem that Windows 98 bootable floppy disk causes system hang
up during loading CD-ROM driver when "OnChip Serial ATA" is set
to"Auto" or "Enhanced Mode".
- Removed the option "Force Update ESCD".
- BIOS Compile Date: 6/10/2003.
|
|
|
|
is7g10.exe
|
Bios Issue Date: |
2003/04/11 |
| BIOS ID:10
- First release
- BIOS Compile Date: 4/11/2003.
|
|
|
| Driver:
|
|
disk12.exe
|
Driver Issue Date: |
2003/05/27 |
| SATA driver disk V1.2
http://202.168.194.118/abit/upload/fae/disk12.exe |
|
|
|
10028.exe
|
Driver Issue Date: |
2003/05/20 |
SiliconImage 3112A SATA Driverv1.0.0.28
1.The Driver is for Win9x/Me/2000/XP |
|
|
|
1102.exe
|
Driver Issue Date: |
2003/05/20 |
USB 2.0 Driver
- The Driver is for Win98SE/Me.
- For Windows 2000 users, please upgrade to Service Pack 4 or later.
- For Windows XP users, please upgrade to Service Pack 1 or later.
|
|
|
|
Infinst_autol.exe
|
Driver Issue Date: |
2003/05/20 |
Intel INF Update v5.00.1012
1.The Driver is for Windows* 2000, Windows* 98 SE, Windows* Me, Windows* XP Home Edition, Windows* XP Professional |
|
|
|
nt4_a343.exe
|
Driver Issue Date: |
2003/05/20 |
Audio Driver 3.43
1.The Driver is for WinNT |
|
|
|
wdm_a343a.exe
|
Driver Issue Date: |
2003/05/20 |
Audio Driver 3.43
1.The Driver is for Win98SE /Me/2000/XP. |
|
|
|
vxd_a343.exe
|
Driver Issue Date: |
2003/05/20 |
Audio Driver 3.43
1.The Driver is for Win95/98 |
|
|
|
iaar30_multi.exe
|
Driver Issue Date: |
2003/05/20 |
Intel Application Accelerator RAID Edition v3.0
1.Intel® Application Accelerator RAID Edition for WindowsXP.
2.The floppy disk containing RAID driver files which can be used to pre-install RAID driver during the F6 portion of WindowsXP setup. |
|
|
|
disk.exe
|
Driver Issue Date: |
2003/05/20 |
Intel Application Accelerator RAID Edition v3.0
1.Intel® Application Accelerator RAID Edition for WindowsXP.
2.The floppy disk containing RAID driver files which can be used to pre-install RAID driver during the F6 portion of WindowsXP setup. |
|
|
|
3C940_lan_driver_w98.zip
|
Driver Issue Date: |
2003/05/13 |
On Board Lan Driver
1.The Driver is for Win98 only |
|
|
|
|
|
;)
