|
|
| BIOS 更新注意事項:
- 如果您需要更進一步的資訊來得知您的主機板型號版本、或是如何更新BIOS,請連結
這裡.
- 請注意,要更新 BIOS,除了需下載 BIOS 檔案外,您還需要 Flash
Utility 。在較新版本 (2001 年 8 月之後) 的 BIOS 檔案中則已包含了更新程式,但較舊版本仍需另外下載。
- 其它 BIOS 相關問題,請按這裡
- 如果您不需要新版 BIOS 所需的改進或修正,您並不需要更新 BIOS。
- 您不需要每一版 BIOS 漸次更新,只要直接更新至最新版本即可包含之前的所有修正跟改進。
- 在更新 BIOS 之後,CMOS 資料將會消失。在重新開機後,您必需進入 BIOS 重新設定您的系統資訊。
| 主機版>Socket 478>VI7
| Bios Issue Date:2004/11/18 | BIOS ID:1.8 | |
- 更新 CPU micro code.
- 新增 "PCI Delay Transaction" 功能並預設為 Disable 在"Advanced Chipset Feature" 選項中.
- BIOS 日期: 11/18/2004
|
| Bios Issue Date:2004/05/17 | BIOS ID:1.7 | |
- Please use flash utility
AWDFLASH v8.32 to update VI7 BIOS.
- Change the default year to 2004.
- Update CPU Micro code.
- Add notification when none 80-wire cable is installed.
- Revised some help information.
- Fixed the issue that can't select SCSI boot ID with some SCSI card.
- Fixed an issue where the PS/2 wheel mouse does not respond under certain
conditions:
- Using certain PS/2 wheel mice and certain USB keyboards.
- PS/2 wheel mouse works fine but loses response on 1st, 3rd,
5th... time restarting windows. However, it works fine on 2nd,
4th... windows restart.
- For "PS/2 wheel mouse + PS/2 keyboard" and
"USB wheel mouse + USB keyboard ", there no
problems at all.
- Shows MAC Address of onboard LAN chip as NONE in System Configuration section.
If "Onboard Network Controller" is disabled.
- BIOS compile date: 05/17/2004
|
| Bios Issue Date:2003/12/25 | BIOS ID:1.6 | |
- 請使用AWDFLASH
v8.24F 進行VI7 BIOS更新。
- 增加Intel P4 Extreme Edition 支援。
- 修正當使用P4 3.06GHz CPU在P4 Max_power時會當機。
- 修正 DMI 資訊。
- 修正 IDE controller 開啟時仍會有裝置分配到IRQ 14或15。
- 新增在 DRAM timing item中顯示 SPD值。
- 修正Clear CMOS後開機畫面缺少 Intel brand name。
- 修正 BIOS 無法將 IDE 裝置指訂為 PIO mode。
- 新增 CPU 風扇失效警告選項。
- 移除 "Virus Protection"字串。
- 將 "Shutdown when CPU fan fail" 預設值設為 "Disabled"。
- 修改 "Set IRQ-5 assigned to" 的預設為 "PCI Device"。
- BIOS 日期:12/25/2003。
|
| Bios Issue Date:2003/11/12 | BIOS ID:1.5 | |
- 請使用更新程式 AWDFLASH
v8.24F 更新 VI7 BIOS。
- 新增 "DDR DQS & DQ Output Delay" 選項 用來增加 DDR400 及更快記憶體
模組的相容性。如下所列的預設值可適用於絕大部份的記憶體模組。然而,
如果記憶體使用不穩定,使用老可自行調整設定值。
-DQS Output Delay: 2B
-DQ Output Delay:2C
- 當使用 DDR200/266/333 模組時,上述選項將自動調整並隱藏。
- BIOS日期: 11/12/2003
|
| Bios Issue Date:2003/10/24 | BIOS ID:1.3 | |
- Please use flash utility AWDFLASH
v8.24F to update VI7 BIOS.
- Add PIRQ 4~7 in the "PnP/PCI Configuration".
- Fixed the problem where Windows scheduled tasks cannot wake the system
up if the RTC alarm is enabled.
- Fixed the problem where the system cannot boot into Windows if
- The OS is installed on the SATA hard disk when both the SATA and PATA
hard disks are present
- The PATA hard disk is removed after the OS installation.
- Enhanced "Fan Fail Shutdown" function.
- Fixed wording problem in the "Time Alarm" function.
- Reserved IRQ9 for ACPI in the "PnP/PCI Configuration".
- BIOS compile date: 10/24/2003.
|
| Bios Issue Date:2003/09/05 | BIOS ID:12 | |
- 修正 SATA Rx5E[3:0] 的數值。
- 自動偵測IRQ 12.14.15,若無安裝device 才可以給BIOS中的PIRQ 指定。
- 增加HDD被更動的warning message 並增加BIOS Feature => HDD Change Message 控制選項。
- 在BIOS POST第一個畫面中移除"An Energy start ally"字串。
- 修正 ACPI function。
- 修改BIOS Setup 中PC Health內選項字串"DDR VDDQ Voltage" to "DDR VTT
Voltage"。
- 修正系統由S3與S1 resume後,FAN fail shutdown 功能失效。
- 修改System configurations 中字串"DDR at DIMM(s)" to "DDR at DIMM"。
- 修正DMI 出現兩個CPU Information並移除DMI中COM2 information.
- BIOS 日期: 9/05/2003。
|
| Bios Issue Date:2003/08/14 | BIOS ID:11 | |
- 請使用更新程式AWDFLASH
v8.24F 更新VI7 BIOS。
- 修正Clear CMOS後,USB無法使用的問題。
- 修正BIOS load Fail-safe default後造成系統無法開機的問題。
- Boot device 字串"ZIP100"改為"ZIP100/250" “USB-ZIP"改為"USB-ZIP\LS120" 。
- 將Intel OSB畫面下方的文字訊息,移到畫面下方的中間位置。
- BIOS SETUP畫面中右下角新增BIOS information。
- BIOS 日期: 8/14/2003。
|
| Bios Issue Date:2003/08/01 | BIOS ID:10 | |
- 首次發行。
- 請使用更新程式AWDFLASH
v8.24F 更新KV7 BIOS。
- BIOS 日期: 8/01/2003。
|
|
|
| |