1. SATA HDDと1394ディバイスの間の安定性を向上。
2. BIOS更新日: 12/28/2004

1. Added adjustable MAX & MIN multiplier item for certain retail INTEL CPUs.
2. Update CPU micro code.
3. Supported certain SATA CDROM when "OnChip Serial ATA" in "Enhanced Mode".
4. Revised wording in PC health item.
5. BIOS compile date: 11/01/2004

1. CPUとの相性を増加.
2. 起動する時の一部のECCメモリのパフォーマンスを増加.
3. BIOS更新期日: 08/30/2004

1. ”IDE Bus Master”の初期値設定を“Enabled”に変更.
2. CPU micro codeを更新.
3. BIOS更新日時: 06/25/2004

1. "OnChip SATA Raid Rom" アイテムがdisabledにならないという問題を修正しました。
2. "ALT+F2" ホットキー機能用の AWDFLASH v8.32サポートを追加しました。
3. パワーサプライの互換性を拡張しました。
4. CPU temperatureの部分を修正しました。
5. CPU micro codeを更新しました。
6. BIOS更新日時: 04/27/2004

1. オンボードネットワークコントローラがdisabledの時、system configuration tableのMACアドレスステイタスの文字を"None"に改正しました。
2. CPUのマイクロコードを更新しました。(0F25h/1Bh, 0F32h/08h, 0F34h/0Ch)
3. BIOS 更新日時: 03/30/2004

1. Updated Prescott CPU micro code.
2. Enhanced compatibility with certain non-RAID Cards.
3. Enhanced compatibility with WD1200JB-SATA hard disk.
4. Updated SiliconImage 3112 controller ROM to version 4.2.47.
5. Updated INTEL RAID BIOS to version 3.5.0.3003.
6. BIOS compile date: 02/24/2004.

1. Updated CPU micro code for Prescott.
2. Changed default RTC year to 2004.
3. Updated Intel OSB logo.
4. Fixed an issue where a system with BIOS 20 will hang at post code "AF" with certain memory modules is installed.
5. BIOS compile date: 01/28/2004

1. Intel On Screen Branding (OSB) ロゴを更新しました。
2. BBSコードを更新しました。 これによりさまざまなSCSIカードで 繰り返し起こるブートの問題を修正しました。
3. システムがWindowsモードに入らないという問題を修正しました。
   1) SATAとPATAハードディスクがある時、 OSが SATAハードディスクにインストールされます。
   2) PATAハードディスクがOSのインストールの後に削除されます。
4. CPU Micro Codeが更新されました。
5. BIOS更新日時: 12/31/2003
   

1. Updated CPU micro code.
2. Added notification when 80-wire cable is not installed.
3. Fixed a problem where the system hangs if
   1. DRAM ratio is set to 5:4 or 3:2
   2. DRAM timing by SPD
   3. N/B strap CPU as FSB800
4. BIOS compile date: 11/18/2003

1. Fixed the problem that the hard disk on IDE-1 may not be detected by when "OnChip SATA" is set to RAID.
2. Fixed the problem that CAS latency can not be set manually when the CPU: DRAM is set to PSB800/5:4 or PSB800/3:2.
3. Remove some string in "PnP/PCI Configuration".
4. Fixed the problem that system will reboot instead of shutdown when the "Wake Up by Alarm" is enabled.
5. Fixed the problem that there will be some wording error when set "Time Alarm".
6. Fixed the problem that the system will shutdown if the fan speed is too low and the "Shutdown When CPU FAN Fail" is enabled.
7. Enhance USB card reader compatibility.
8. Add Pentium 4 Extreme Edition support.
9. Fixed HDD size detected as 136GB when 200/250/300 GB SATA drives are connected to SATA1 or SATA2 (ICH5 SATA channels)
10. Show the correct subsystem device ID of the USB 2.0 and IEEE 1394 controller. (IC7 only)
11. Fixed the problem that certain CD/DVD-ROM could not be correctly detected when there is a HDD drive attached on the same IDE cable.
12. BIOS compile date: 10/30/2003
    

1. Added hot key wording to enter BIOS setup when full screen logo enabled.
2. Changed the option wording from "OnChip SATA" to "OnChip SATA RAID" for "Bootable Add-in Device".
3. Changed the default setting of "OnBoard IR Port" to "Disabled".
4. Fixed the booting failure problem of Maxtor SATA HDD (Model name: 6Y120M0) in ICH5R RAID 0 status.
5. Changed the option wordings of "Boot Device" from "ZIP100" to "ZIP100/250" and from "USB-ZIP" to "USB-ZIP/LS120".
6. Enhanced the system stability when over clocks the CPU FSB over 255 MHz with CPU:DRAM = 1:1 setting.
7. Revised the wording of memory status from "DDR at Bank" to "DDR at DIMM" in system configuration table.
8. Included new Intel CSA LAN boot agent v1.21.07 for 82547EI chip (for IC7-G only).
9. Displayed correct specification of DDR200 memory module during POST.
10. Fixed the problem that specific CD-ROM device could not be correctly detected when there is specific HDD connected onto the same IDE cable.
11. Updated CPU micro code (0F24H/1EH, 0F25H/15H, 0F27H/37H, 0F29H/17H).
12. Revised display wording of "Time Alarm" menu box in BIOS setup.
13. BIOS Compile Date: 8/21/2003.
    
    
    

1. Updated CPU micro code (0F12H/2EH, 0F13H/05H)
2. Fixed the problem that no effect during POST if change "Delay IDE Initial" in BIOS setup.
3. Added function to automatically detect the IRQ availability and dynamically update assignation table in PnP/PCI configurations setup page.
4. Revised the wording of IEEE1394 controller in PCI device listing.
5. Fixed the problem that DOS4GW.EXE causes system hang-up in DOS environment.
6. Added function that automatically detects CPU operation speed after discharging CMOS data.
7. Added SATA RAID 1 function for Intel ICH5R south bridge.The IAA RAID driver should be updated to v3.5 or later to support RAID 1 in Windows XP.
   http://downloadfinder.intel.com/scripts-df/download.asp?url=/6363/eng/iaar35_enu.exe&ProductID=961
8. BIOS Compile date: 7/11/2003.

BIOS ID:15

1. Shows the correct IRQ of IDE Controller in PCI Devices Listing.
2. Fixes CPU Thermal Throttling behavior while under minus temperature, and supports minus temperature reading in BIOS Setup.
3. Fixes the problem that system could not automatically get into S4 mode, after enabling Power Scheme of "power Option" under Windows XP.
4. Fixes wrong system operation caused by incomplete discharging CMOS data by CCMOS jumper.
5. BIOS Compile Date: 6/23/2003.

New Fixes/Features

1. Added new option "HDD Change Message" in Advanced BIOS Features and the default setting is "Disabled". If this option is changed to "Enabled", the system will show warning message and prompt for a confirmation when one or more than one HDD had been added into or removed from the system.
2. Changed the default setting of "OnCip Serial ATA" to "Auto".
3. Revised the wording of IDE channels inside the BIOS Setup. IDE Channel 0, 1, 2, and 3 are changed to 1, 2, 3, and 4.
4. Revised the error reading of fan speed for specific CPU cooling fan when FanEQ 60% enabled.
5. Fixed "CPU THRM-Throttling" function.
6. Fixed the slow detection problem when HDD simulation card installed.
7. Fixed the problem that SMARTDRV.EXE malfunction in DOS 6.22 environment.
8. Fixed the problem that Windows 98 bootable floppy disk causes system hang up during loading CD-ROM driver when "OnChip Serial ATA" is set to "Auto".
9. Added "Game Accelerator" technology.
10. Removed options "Virus Warning" and "Force Update ESCD".
11. BIOS Compile Date: 6/9/2003.

1. Fixed DOS 6.22 booting failure from FAT16 partition.
2. Revised display mode of HTT CPU LOGO.
3. Fixed BIOS hang-up problem which is caused by specific CPU cooling fan reporting error RPM to BIOS when CPU FanEQ 60% enabled.
4. Revised the following default settings in BIOS setup page.
   - Bootable Add-in Device: PCI Slot Device
   - CPU FanEQ Active Temperature: 70 C
   - CPU Warning Temperature: 85 C
5. Enabled "IDE Block Mode" and hid the option.
6. Revised ICH5R RAID BIOS display issue.
7. Fixed COM2 device existing in Windows Device Manager problem.
8. Revised power-on delay time from 4~5 seconds to 1~2 seconds after AC powerloss and resume.
9. BIOS Compile Date: 5/19/2003.

BIOS ID: 11

1. Added new option "SATA RAID ROM" to setup the BIOS of onboard and on-chip SATA.
2. Revised setup menu for on-chip Serial ATA.
3. Fixed IOMEGA USB-ZIP 250 boot issue.
4. Added SVID/SDID for IC7 and IC7-G respectively.
5. Added "Intel on-screen branding" and could be enabled/disabled.
6. Added new options "Read Delay (Trd)" and "Turbo Mode" for system performance.
7. Fixed on-chip SATA boot issue while another bootable hard drives exist and attached to IDE-1 or IDE-2.
8. Updated memory reference code and ICH5 BIOS spec to v1.2.
9. Updated ICH5 SATA RAID BIOS to v3.0.0.2344.
10. Updated CPU micro code (CPU: 0F29H, ID=11H).
11. Added new options "Refresh Cycle Time", "Read Delay Adjust (tRD Adj)", "Command Per Clock (CPC)", and "Performance Mode".
12. Added new option "IDE Bus Master".
13. Added CPU multiplier 8X for engineering sample CPU and maximum CPU frequency 412 MHz.
14. Fixed DRAM timing settings while manually set them.
15. BIOS Compile Date: 4/30/2003.

1. First release.
2. BIOS Compile Date: 3/27/2003.